Tuesday, April 5, 2016

Today's Machining Project....

 

 Heat Exchanger Manifold Fixture








6 comments:

  1. Oh! I thought it was a better mouse trap.

    ReplyDelete
    Replies
    1. I wish then I could make thousands of them!!

      Delete
  2. You can tell an expert is machining that!!! Which way does the mouse go in???

    ReplyDelete
  3. Thats a tiny heat exchanger. What is it for?

    Exile1981

    ReplyDelete
    Replies
    1. I thinks it's a soldering fixture for the end tubes.

      Delete
    2. Thats kind of what I thought. I assume it is hollow on the other side andvit has a similar sister one?

      Its just the ones i normally see are as big as a truck.

      Exile1981

      Delete

Leave us a comment if you like...